Setup; Installation - Hall Research Technologies FXT-460 User Manual

3.0 Setup

Installation


On both the FXT-460-S and FXT-460-R, make sure the SFP modules are fully
inserted as they could have become disconnected during shipping.

Interconnect the FXT-460-S and FXT-460-R with an LC®/PC fiber optic cable.
NOTE

Optionally, Connect the RS-232 TX, RX and GND contacts to compatible
controllers (e.g., PC or RS-232 controller).
Direction of data flow is shown in section below.
o
RS-232 passes bi-directionally between the FXT-460-S and FXT-460-R at
o
115200 baud only.

FXT-460-S
Optionally,
o
HDMI compatible sink to the HDMI OUT connector.
NOTE

Optionally,
o
 Connect the SPDIF OUT and/or L/R OUT audio outputs to a compatible
audio device. (e.g., headphones, assistive listening devices, or Audio
Amplifier such as the
Optionally,
o
Connect the audio to embed to the SPDIF IN and/or L/R IN connector(s).



FXT-460-R
Hall Research can provide pre-terminated LC fiber
optical cable at custom
mode or multimode fiber optic cable. Single mode
fiber is recommended due to its 10 km range
Connect an HDMI source to the HDMI IN connector and if desired a
A video source is NOT required to embed audio onto
the HDMI output at the FXT-460-R. If no HDMI source
signal is present, the HDMI Output at the FXT-460-R
will be a black screen at 480p resolution.
for audio extraction at the transmitter
Hall Research AMP-4840 or
if you don't want to extend the original HDMI audio
HDMI Fiber Optic Extender
lengths. You can use single
© Copyright 2020 Hall Research, LLC.
AMP-7040).
5