DeVilbiss T-AGPZ-F158 Operation Manual page 6

need to change the needle seal kit. The stem part of the tool is used for checking and adjusting the
tightness of sealing. (If it is too tight, the needle can't move smoothly.)
*At the initial setting it has been set with the torque of 0.5N・m. After you reassemble all the
parts and using the Cylinder Air at 0.2MPa, if the needle does not move smoothly, need to
readjust the needle seal.
*Recommended Front Cylinder Air Pressure is 0.25MPa and Rear Cylinder Air Pressure is 0.4MPa.
*It is recommended to purchase T-AGPZ-34 (33) special tool, since the general tools in the market
may not be easy to use for inserting the needle seal and adjusting the tightness.
－ 6 －