Page 1
SB-JE-T-AGPZ-B T-AGPZ-F158/F159/F208/F209/S8/S9 COMPACT AUTO. GUN OPERATION MANUAL IMPORTANT: Read and follow all instructions and SAFTEY PRECAUTIONS before using this equipment. DESCRIPTION T-AGPZ GUN is a low flow rate automatic spray gun specifically designed and suited for spraying small objects. This spray gun also has greatly improved maintenance performance thanks to the use of tungsten carbide in the fluid tip and needle which dramatically improves durability and anti-clogging properties, along with our industry-first “2 sep triggering system, which cuts cleaning time during color change to...
SAFETY PRECAUTIONS This manual contains important information that ALL users should know and understand BEFORE using this equipment. This information relates to USER SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information, we use the following terms to draw your attention to certain equipment labels and portions of this manual.
Noise Levels The continuous A-weighted Wear earplugs when using the spray gun. sound pressure level of this spray gun may exceed 85dB(A) depending on the air cap/nozzle set-up being used. Sound levels are measured using an impulse sound level meter and analyzer, when the gun is being used in a normal spraying application.
INSTALLATION Figure 1. Dimensions CAUTION The air supplied to the gun should be clean air that removed any impurities. OPERATION Full-Auto Type (F) 1. Mix, prepare and strain the coating material to be sprayed according to paint manufacturer’s instructions. 2. Adjust the Front CYL air at 0.25MPa and Rear CYL air at 0.4MPa. 3.
Page 5
CLEANING 1. When you clean the Full-Auto type gun, Rear CYL air should be stopped. In case of Semi-Auto type gun, you should set the dial to “CLEAN” position. 2. Relieve air pressure from pressure tank. Carefully follow instructions in bulletin sent with tank. 3.
Page 6
need to change the needle seal kit. The stem part of the tool is used for checking and adjusting the tightness of sealing. (If it is too tight, the needle can’t move smoothly.) *At the initial setting it has been set with the torque of 0.5N・m. After you reassemble all the parts and using the Cylinder Air at 0.2MPa, if the needle does not move smoothly, need to readjust the needle seal.
Page 8
Item Part Number Description Q’ty Reference 1 T-AGPZ-6 Retaining Ring (with seat) 2 JJ-50-K5 Seat Kit of 5 3 Refer to Chart 1 Air Cap 4 Refer to Chart 2 Tip, Needle & Piston Set 5 T-AGPZ-10-1 Needle Seal Kit Item no.
SERVICE CHECK Normal Spray Pattern The proper combination of fluid pressure, fan and atomization air pressure, and fluid tip size should result in a pattern of this shape. PROBLEM CAUSE CORRECTION Will not spray. No pressure to gun. Check air and material lines. Piston stops moving.