Specification - DeVilbiss T-AGPZ-F158 Operation Manual

Noise Levels
Spraying solvent
MISUES:
・ All spray guns project particles at high velocity and must never be aimed t any part of body.
・ Never exceed the recommended safe working pressure for any of the equipment used.
・ The fitting of non-recommended or non-original accessories or spare parts may create hazardous
conditions.
・ Before dismantling the equipment for cleaning or maintenance, all pressures, air and material, must be
isolated and released.
Disposal of non-metallic materials must be carried out in an approved manner. Burning may
generate
toxic fumes. The removal of waste solvents and coating materials should be carried out by an
authorized local waste disposal service.

SPECIFICATION

Max. Air Pressure
Recommended Fluid Pressure
Recommended Atomization
Pressure (CAP Air)
Cylinder Air Pressure
Fluid Inlet
FAN / CAP Air Inlet
Cylinder Air Inlet
Weight
The continuous A-weighted
sound pressure level of this
spray gun may exceed
85dB(A) depending on the air
cap/nozzle set-up being
used. Sound levels are
measured using an impulse
sound level meter and
analyzer, when the gun is
being used in a normal
spraying application. Details
of actual noise levels
produced by the various air
cap/nozzle set-ups are
available on request.
Pressured air/fluid passage
may be broken when
cleaning or flashing with
solvent.
The solvent may be harmful
if contacted with eyes.
FULL-AUTO
0.7MPa (7 bar)
0.01MPa-0.1MPa (0.1-1 bar)
Air 0.1MPa – 0.3MPa (1-3 bar)
Front CYL 0.25MPa
Rear CYL 0.4MPa
6 x 4mm
6 x 4mm
6 x 4mm
550 g
Wear earplugs when using the spray gun.
Always wear eye protection when spraying or
cleaning the equipment.
x 2
x 2 (Front & Rear)
－ 3 －
SEMI-AUTO
0.7MPa (7 bar)
0.01MPa-0.1MPa (0.1-1 bar)
0.1MPa – 0.3MPa (1-3 bar)
0.25 – 0.4MPa
6 x 4mm
6 x 4mm x 2
6 x 4mm
507 g