Led Indicator - HYT TC-518 OBR Owner's Manual

Radio Overview
Note:
Short Press
Long Press
﹡LED Indicator
LED indications and alert tones are shown in the table below (see Advanced
Operations for details):
Status
Power On
Radio Standby
Low Battery Alert
Transmitting
Receiving
Scanning
Key press no longer than 1 second.
Key press longer than 1 second.
LED Indication and Alert Tone
1. The power-on alert tone is heard when the radio
is powered on.
2. When the current channel is a blank channel,
beeps are heard.
The LED flashes blue if no operation is made or
no carrier is present within 2s. You can enable/
disable this LED indication via CPS software and
programming cable.
The LED flashes red and a low pitched tone is heard
every ten seconds.
1. Red LED glows while the radio is transmitting.
2. When transmission times out, continuous beeps
are heard.
3. TOT Pre-alert: one beep is heard.
4 . Tr a n s m i t t i n g P T T I D : c o n t i n u o u s b e e p s
(programmable via CPS software and programming
cable) are heard.
5. Transmitting PTT ID is completed: a short beep
(programmable via CPS software and programming
cable) is heard.
The LED glows green when carrier presents.
1. The LED flashes green every 1 second when
scanning is in process.
2. Scan Start Tone (programmable via CPS software
with programming cable): one beep is heard.
3. Green LED solidly glows when signal is received.
4. Scan Stop Tone (programmable via CPS software
with programming cable): one beep is heard.
Two beeps sound when the feature is disabled.
5