EIP CD425 Owner's Manual page 2

Dehumidifiers remove moisture from the air that is circulating through the unit.
The resulting reduction of relative humidity helps prevent rust, rot, mould,
mildew and condensation within the room, or other enclosed spaces where
the dehumidifier is used.
A dehumidifier consists of a motor-compressor unit, a refrigerant condenser,
an air circulating fan, a refrigerated surface, a means of collecting and
disposing the condensed moisture and a cabinet to house these components.
The fan draws air through the refrigerated surface and cools it below its dew
point, removing moisture which is collected and led away. The cool air then
passes the hot condenser, where it is reheated. With the addition of other
radiated heat the air is discharged into the room at a higher temperature but
lower relative humidity than when the air entered the unit. Continuous
circulation of the room air through the dehumidifier unit gradually reduces the
relative humidity in the room.
The CD425 is a self contained low temperature dehumidifier. All electrical
contactors, overloads, etc, are housed in an electrical box built inside the unit.
The unit is equipped with a defrost valve which energises every 42 minutes to
clear any ice formation on the evaporator coils. This allows the unit to operate
at much lower temperatures. The control panel gives indication of the set
humidity, drying and defrosts status.
The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
INTRODUCTION
Page 2 of 13
Drawing : - TPC127A
Issue : - 2
Date : - 28/05/12