Burners; Controls; Cookware; Dual-Flame Stacked Burners - Monogram 30" Owner's Manual

Professional dual fuel ranges
Hide thumbs Also See for 30":
Table of Contents

Advertisement

Available languages

Available languages

Cooktop Controls
Professional
Dual
Fuel
Range
Electronic
ignition
&
autornatic
reign/t/on
The range is equipped
with electronic
ignition
which eliminates
the need for a standing
pilot
light,
The burners on this range will automatically
relight if the flame goes out,
All surface burner igniters will spark and make
clicking sounds when any burner is turned on,
Do not touch any of the burners when igniters
are clicking,
Occasionally
the burners may spark if excess
wind or a draft blows the flame away from the
burner's flame sensor,
The griddle and IR (infrared) grill are equipped
with GIo-Bar igniters, The GIo-Bar remains
energized
whenever
the griddle or IR grill is in
use to ensure the burner always
stays lit,
In case of e power outage,
you can light the
surface
burners on your cooktop with a match,
Hold a lighted match to the burner, then turn the
knob to the LOW position, Use extreme
caution
when lighting
burners
this way.
Do not attempt
to light the grill or griddle during
a power outage, The gas to these burners will
automatically
shut off during a power outage,
To fight
a surface
burner
Push the control knob in and turn it
counterclockwise
to the LITE position,
ON Indicator
Light
After the burner ignites, turn the knob to adjust
the flame size,
To turn a burner off, turn the knob clockwise,
as far as it will go, to the OFF position,
Do not operate a burner for an extended
period of time without
cookware
on the grate,
The finish on the grate may chip without
cookware
to absorb the heat,
The indicator
light on each bezel verifies the
burner is on, However, it should not be a
substitute
for visually checking
the flame at the
burner,
Dual-flame
stacked
burners
All surface burners on your range have two sets
of flames stacked
one on top of the other; the
dual-flame
burners have a lower (simmer) flame
and a upper (main) flame,
When a burner is turned on, the lower flame will
always light and stay on,
Simmering:
The stacked
burner design provides a wide
range of heat settings
with which to simmer,
Depending
on the type and quantity
of food, and
pan size, the flame can be adjusted to suit your
specific need, The lowest setting uses only the
lower flame and can maintain
delicate foods at
a safe 140°F,
Cooking:
Settings from LO to ×-HI will use both upper
and lower flames, Use LO to HI for all purpose
cooking, Use HI or X-HI (highest setting) with
larger diameter
cookware,
_
ower
Flame
Upper
Flame
Lower Flame
X-HI and HI are very high heat settings and
are intended to sear foods quickly and boil
large quantities
of water,
10

Advertisement

Table of Contents
loading

Table of Contents