Power The Wireless Forecast Station; A/C Power Adapter; Batteries; Install Batteries In The Outdoor Transmitter - La Crosse Technology C86371 Instruction Manual

Power the Wireless Forecast Station

The Wireless Forecast Station can be powered by the 5-volt a/c adapter or batteries.

A/C Power Adapter

Insert enclosed 5-volt a/c power adapter into a wall outlet, then into the Wireless Forecast Station.
Battery
Compartment

Batteries

1. Remove battery cover: Slide tab to the right and pull out to remove battery cover.
2. Install three fresh AA batteries according to the polarity markings.
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Lithium, Standard, or Rechargeable Batteries
If the Wireless Forecast Station does not display indoor temperature after 60 seconds, remove adapter
and batteries, and wait for at least 60 seconds before repeating the setup process.

Install Batteries in the Outdoor Transmitter

1. Slide the battery cover down, then lift off the back of the transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two fresh AA batteries into the transmitter. Observe the correct
polarity (see marking inside battery compartment).
4. Keep transmitter 5-10 ft. from the Wireless Forecast Station during setup.
5. After 15 minutes, if the outdoor temperature shows on the Wireless
Forecast Station, you can move the outdoor transmitter outside to a
shaded location within range of the Wireless Forecast Station.
La Crosse Technology
5-Volt a/c adapter
Page 4