Power The Wireless Weather Station; A/C Power Adapter; Batteries; Install Batteries In The Outdoor Transmitter - La Crosse Technology S84193 Instruction Manual

Power the Wireless Weather Station

The weather station can be powered by the 5-volt A/C adapter or with batteries.

A/C Power Adapter

Insert enclosed 5-volt A/C power adapter into a wall outlet, then into the weather station.
If the weather station does not display indoor temperature after 60 seconds, remove adapter and batteries,
and wait for at least 60 seconds before repeating the setup process.

Batteries

1. Remove battery cover: Slide tab to the left and pull out to remove battery cover.
2. Install three fresh AAA batteries according to the polarity markings.
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Lithium, Standard, or Rechargeable Batteries
If the weather station does not display indoor temperature after 60 seconds, remove adapter and batteries, and
wait for at least 60 seconds before repeating the setup process.

Install Batteries in the Outdoor Transmitter

1. Slide the battery cover down, then lift off the front of the TX141TH-B transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Insert two fresh AA batteries into the transmitter. Observe the correct polarity (see marking
inside battery compartment).
3. Keep transmitter 5-10 ft. from the weather station during setup.
4. After 15 minutes, if the outdoor temperature shows on the weather station, you can move the
outdoor transmitter outside to a shaded location within range of the weather station.
4