Clear Memory Mode - Subaru 2001 Forester Service Manual

Immobilizer (Diagnostics)

7. Clear Memory Mode

A: OPERATION
1. WITH SUBARU SELECT MONITOR
S009513A1601
1) On the Main Menu
the {2. Each System Check} and press the [YES]
key.
2) On the System Selection Menu
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after displayed the infor-
mation of engine type.
4) On the Engine Diagnosis
select the {Clear Memory} and press the [YES]
key.
2. WITHOUT SUBARU SELECT MONITOR
No.
1 CHECK STATUS OF CHECK ENGINE MAL-
FUNCTION INDICATOR LAMP (MIL).
1) Turn ignition switch to OFF.
2) Set shift lever to neutral position (MT
vehicles), or set selector lever to "P" position
(AT vehicles).
3) Connect test mode connector and read
memory connector.
4) Turn ignition switch to ON.
2 CHECK DIAGNOSTIC TROUBLE CODE
(DTC).
1) Set selector lever "N" position, and then set
selector lever to "P" position again (AT
vehicles only).
2) Start the engine.
3) Drive vehicle at speed greater than 11
km/h (7 MPH) for at least one minute.
4) Warm-up engine above 2,000 rpm.
CLEAR MEMORY MODE
S009513
S009513A16
display screen, select
display
display screen,
Step
5) When the 'Done' and 'Turn Ignition Switch OFF'
are shown on the display screen, turn the Subaru
Select Monitor and ignition switch to OFF.
NOTE:
¼ After the memory has been cleared, the ISC
must be initialized. To do this, turn the ignition
switch to the ON position. Wait 3 seconds before
starting the engine.
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
S009513A1602
Check
Does the MIL come on?
Does the MIL indicate diag-
nostic trouble code (DTC)?
<Ref. to IM-25, LIST, List of
Diagnostic Trouble Code.>
IM-18
MONITOR OPERATION
Yes
Go to step 2. Check the follow-
ing and repair if
necessary.
NOTE:
¼ Open or short
circuit in engine
control module
power supply or
ground line
¼ Open or short
circuit in CHECK
ENGINE malfunc-
tion indicator lamp
Record diagnostic Turn ignition
trouble code. switch to OFF,
Repair the trouble Disconnect read
cause. memory connec-
tor and test mode
connector. Com-
plete clear
memory mode.
No