Subaru Select Monitor - Subaru 2001 Forester Service Manual

Immobilizer (Diagnostics)

5. Subaru Select Monitor

A: OPERATION
1. HOW TO USE SUBARU SELECT
MONITOR
S009503A1605
1) Prepare Subaru Select Monitor kit.
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to IM-4, SPECIAL TOOLS, PREPARATION
TOOL, General Description.>
4) Connect Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
(2) Connect diagnosis cable to data link con-
nector.
SUBARU SELECT MONITOR
S009503
S009503A16
S2M0285
S2M0286A
S2M2157
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor.
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
6) Using Subaru Select Monitor, call up diagnostic
trouble code(s) and various data, then record
them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE.
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to IM-16,
Read Diagnostic Trouble Code.>
3. INTERFACE CHECK
NOTE:
Communication line between ECM and IMM ECM
can be checked in
Mode . This is referred to as "interface check".
1) Connect select monitor.
2) Set the System Operation Check Mode
menu display screen then select
System .
3) Screen indicates as shown.
IM-14
S2M0288A
S009503A1606
S009503A1604
System Operation Check
Immobilizer
S6M0210