Accessories - Hilti DX462CM/HM Operating Instructions Manual

onto a hard surface, no matter at which angle the impact
occurs.
The trigger safety device
cannot be fired simply by pulling the trigger only. The
tool can be fired only when pressed against the work
surface.
The contact pressure safety device
en
to be pressed against the work surface with a signifi-
cant force. The tool can be fired only when pressed ful-
ly against the work surface in this way.
In addition, all Hilti DX tools are equipped with an unin-
tentional firing safety device
from firing if the trigger is pulled and the tool then pressed
against the work surface. The tool can be fired only when
it is first pressed (1.) against the work surface correct-
ly and the trigger then pulled (2.).
4. Cartridges, accessories and characters
Marking heads
Ordering designation
X-462 CM
X-462 HM
Pistons
Ordering designation
X-462 PM

Accessories

Ordering designation
X-PT 460
Spares pack HM1
Centering devices
Characters
Ordering designation
X-MC-S characters
X-MC-LS characters
18
Printed: 12.08.2013 | Doc-Nr: PUB / 5126470 / 000 / 01
ensures that the cartridge
3
requires the tool
4
. This prevents the tool
5
Application
Polyurethane head for marking up to 50°C
Steel head for marking up to 800°C
Application
Standard piston for marking applications
Application
Also known as the pole tool. An extension system that allow marking on very hot
materials at a safe distance. Used with DX 462HM
To replace the screws and the O ring. Only with X 462HM marking head
For marking on curve surfaces. Only with X-462CM marking head. (Axle A40-CML
always required when centering device is used)
Application
Sharp characters cut into the surface of the base material to form an impression.
They can be used where the influence of marking on the base material is non-critical
For use in more sensitive applications. With a rounded radius, low-stress characters
deform, rather than cut, the surface of the base material. In this way, their influence
on it is reduced
2
3
4
5
2
1