Technical Data; Before Use - Hilti DX462CM/HM Operating Instructions Manual

X-MC-MS characters
Please contact your local Hilti Center or Hilti representative for details of other fasteners and accessories.
Cartridges
Ordering designation
6.8x11 M green
6.8x11 M yellow
90% of all marking can be carried out using the green cartridge. Use the cartridge with the lowest possible power in order to keep wear on
the piston, impact head and marking characters to a minimum
Cleaning set
Hilti spray, flat brush, large round brush, small round brush, scraper, cleaning cloth.

5. Technical data

Weight
Tool length
Recommended maximum fastening rate
Cartridges
Right of technical changes reserved!

6. Before use

6.1 Tool inspection
● Ensure that there is no cartridge strip in the tool. If
there is cartridge strip in the tool, remove it by hand from
the tool.
● Check all external parts of the tool for damage at reg-
ular intervals and check that all controls operate prop-
erly. Do not operate the tool when parts are damaged or
when the controls do not operate properly. If necessary,
have the tool repaired at a Hilti service centre.
● Check the piston for wear (see "8. Care and mainte-
nance").
Printed: 12.08.2013 | Doc-Nr: PUB / 5126470 / 000 / 01
Mini-stress characters exert even less influence on the base material surface than
low-stress. Like these, they have a rounded, deforming radius, but derive their
mini-stress characteristics from the interrupted dot pattern (only available on special)
Colour code
Green
Yellow
Power level
Low
Medium
DX 462CM
3.92 kg (8.64 lb)
435 mm (17.13")
700 per hour
6.8/11 M green and yellow
6.2 Changing the marking head
1. Check that no cartridge strip is present in the tool. If
a cartridge strip is found in the tool, pull it upwards
and out of the tool by hand.
2. Press the release button on the side of marking head.
3. Unscrew the marking head.
4. Check the marking head piston for wear (see "Care
and maintenance").
5. Push the piston into the tool as far as it will go.
6. Push the marking head firmly onto the piston return
unit.
7. Screw the marking head onto the tool until it engages.
DX 462HM
4.62 kg (10.19 lb)
425 mm (16.73")
en
19