Phone Features; General Requirements; Headset/Handset Connection; Handset - Aastra 33i User Manual

Chapter 1, Introduction

Phone Features

•
•
•
•
•

General Requirements

The 33i SIP IP Phone requires the following environment:
•
•
•
•
•

Headset/Handset Connection

Handset

Turn the phone over and locate the handset jack marked
cord into the jack until it clicks into place. Then route the handset cord through the
groove as shown in the illustration below. Attach the handset to the other end of the
handset cord.

Headset (Optional)

Turn the phone over and locate the headset jack marked
into the jack until it clicks into place. Then route the headset cord through the groove as
shown in the above illustration.
M
2
M
Three-line adjustable backlit display screen.
3 hard keys as line appearance keys (L1 – L3) with corresponding lamps.
7 programmable keys with status lamps that can be programmed with specific
functions.
Full-duplex speakerphone for handsfree calls.
Built-in-two-port, 10/100 Ethernet switch allowing you to share a connection
with your computer.
A SIP-based IP PBX system or network installed and running with a SIP account
created for the 33i phone.
Access to a Trivial File Transfer Protocol (TFTP) server.
Ethernet/Fast Ethernet LAN (10/100mb).
Category 5/5e straight through cabling.
Power Options:
Power over Ethernet (PoE) 802.3af
–
Inline power injector – An optional accessory necessary only if your network
–
provides no inline power.
– AC power adapter, included with the phone.
. Insert one end of handset
. Insert the headset cord
Aastra – 2741-002