Connections; Connecting The Input/Output Terminals - Pioneer XDJ-RX Operating Instructions Manual

Connections

! Connect the power cord after all the connections between devices have been completed.
! Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
! Refer to the operating instructions for the component to be connected.
! Be sure to use the included power cord.
! When using a LAN cable for connection, be sure to use either the LAN cable included with this product or an STP (shielded twisted pair) cable.
! Do not disconnect the LAN cable when music files and/or information are being shared using PRO DJ LINK.

Connecting the input/output terminals

Rear panel, front panel
Headphones
Power amplifier,
powered speakers,
etc.
R
1
Front panel
1 PHONES terminals
Connect headphones here.
Both stereo phone plugs (Ø 6.3 mm) and stereo mini phone plugs
(Ø 3.5 mm) can be used.
! There are two output terminals (one for a stereo phone jack and
one for a mini-phone jack), but do not use both terminals simulta-
neously. If one is connected or disconnected while the other one
is being used, the volume of the other one in use may increase or
drop suddenly.
2 MASTER1 terminals
Connect a power amplifier, powered speakers, etc., here.
Be sure to use these as balanced outputs. Be careful not to acci-
dentally insert the power cord of another unit.
3 MASTER2 terminals
Connect a power amplifier, powered speakers, etc., here.
4 BOOTH OUT terminals
This is an output terminal for a booth monitor.
5 LINE/PHONO terminals
Connect a phono level output device (analog player (for MM car-
tridges), etc.) or a line level output device (DJ player, etc.) here.
Switch the terminals' function according to the connected device
using the [LINE, PHONO] selector switch on this unit's rear panel.
6 LINE, PHONO selector switch
Switches the function of the [LINE/PHONO] terminals.
7 Kensington security slot
8 LINK terminal
Connect the LAN cable (included) here.
6
En
Power amplifier,
powered speakers, etc.
L
R L
R
2 3 4 5
Rear panel
Computer
rekordbox
Power amplifier
(for booth monitor)
DJ player
L L R
6 7 8 9
9 SIGNAL GND terminal
Connects an analog player's ground wire here. This helps reduce
noise when the analog player is connected.
USB terminal
a
Connect to a computer.
! A USB hub cannot be used.
! To maintain performance, connect the unit and the computer
directly using a USB cable compatible with USB 2.0.
b MIC2 terminal
Connects a microphone here.
c MIC1 terminal
Connects a microphone here.
d AC IN
Connect this to a power outlet.
! Connect the power cord after all the connections between
devices have been completed.
! Be sure to use the included power cord.
DJ
Analog player
software
Microphone
L
R
a 6 5 b c
Microphone
To power outlet
Power cord
d