Connections And Part Names; Connections; Names Of Parts; Rear Panel - Pioneer DDJ-SX2 Operating Instructions Manual

Connections and part names

Connections

! Connect the AC adapter after all the connections between devices have been completed.
Be sure to turn off the power and unplug the AC adapter from the power outlet before making or changing connections between devices.
Refer to the operating instructions for the component to be connected.
! Only use the AC adapter included with this unit.
! Power is supplied to this unit by the AC adapter.
! Connect this unit and the computer directly using the included USB cable.
! A USB hub cannot be used.
! Refer to the operating instructions for the component to be connected.

Names of Parts

 Rear panel

1
1 MASTER OUT 1 terminals
Connect powered speakers, etc., here.
! Compatible with XLR connector type balanced outputs.
2 MASTER OUT 2 terminals
Connect to a power amplifier, etc.
! Compatible with RCA pin-jack type unbalanced outputs.
3 BOOTH OUT terminals
Output terminals for a booth monitor, compatible with balanced or unbalanced
output for a TRS connector.
The master channel sound can be output from the [BOOTH OUT] terminals
regardless of the audio level set for the master channel.
! The sound will be distorted if the level is raised too high when using unbal-
anced outputs.
! The default setting of booth monitor output has been set to output the
microphone sound. In the utilities mode, it is possible to set not to output the
microphone sound.
= Setting the microphone output of the booth monitor (p. 24 )
4 MIC2 terminal
Connects a microphone here.
! The [INPUT SELECT] switch on the main unit's front panel must be set to
[MIC2].
5 CD terminals
Connect to a DJ player or other line level device.
! The [INPUT SELECT] switch on the main unit's front panel must be set to
[CD].
6 PHONO/LINE input terminals
Connect to a phono level (for MM cartridge) output device such as an ana-
log turntable or line level output device such as a DJ player. Depending
on the device connected, the terminal function can be switched using the
[INPUT SELECT] switch in the front of the unit.
2 3 4 5 6 7 6 5 8 9
7 SIGNAL GND terminal
Connect an analog turntable ground wire here. This helps reduce noise when
the analog turntable is connected.
8 MIC1 terminal
Connects a microphone here.
! The [INPUT SELECT] switch on the main unit's front panel must be set to
[MIC1].
! Either an XLR connector or a phones plug (Ø 6.3 mm) can be used.
9 Kensington security slot
USB terminal
a
Connect to a computer.
! Connect this unit and the computer directly using the included USB cable.
! A USB hub cannot be used.
b STANDBY/ON switch
This switches this unit's power between on and standby.
c DC IN terminal
Connect to a power outlet using the included AC adapter (with the power plug
mounted).
! Connect the AC adapter after all the connections between devices have been
completed.
! Only use the included AC adapter.
d Cord hook
Catch the AC adapter's power cord and USB cable on this hook when using this
unit.
! The sound will be interrupted if the AC adapter or USB cable is disconnected
during playback.
a b c d
7
En