Table of Contents
Advertisement
2.4
Completing the Installation
separate interrupts, jumper TP1 (see
the interrupt routing. The following table explains the jumper settings:
Table 2.3
Setting Jumpers
Jumper Setting
Jumper Out (default)
Jumper In
Before replacing the cover on your computer, review this installation
procedure check list. This can save you effort later.
Verify Installation Procedures
Host adapter connection in PCI bus slot secure
Internal SCSI bus connections secure (pin-1 continuity)
External SCSI bus connections secure
Proper SCSI bus termination established
Unique SCSI IDs set and recorded for each device
Step 1. Replace the cabinet cover on your computer.
Step 2. Plug in all power cords, and switch on power to all devices and
your computer.
Step 3. Wait for your computer to boot up.
Step 4. To change the configuration of the LSIU40HVD, see
"Configuring the LSIU40HVD."
Step 5. Finally, refer to the PCI Storage Device Management System
SDMS 4.0 User's Guide (or the guide for the software you plan
to use) to load the driver software for your particular operating
system.
Completing the Installation
Figure
Condition
INTB/ is routed to INTB/ on the PCI bus
INTB/ is rerouted at power up to INTA/ on the PCI bus
A.1) is provided to change
Done
Chapter 3,
2-23
Advertisement
Table of Contents
