Preface; General; Product Introduction - Kemppi Kempomat 2500 Operating Manual

1.

preFaCe

1.1

general

Congratulations on choosing the Kempomat™ equipment. Used correctly, Kemppi products
can significantly increase the productivity of your welding, and provide years of economical
service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the manual carefully before using the equipment for the first time. For your
own safety and that of your working environment, pay particular attention to the safety
instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the
their instructions.
disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
1.2

prOduCt intrOduCtiOn

The power sources Kempomat 3200 and 4200 are compact MIG welding machines, designed
for heavy industrial use. Kempomat 2500 is compact MIG welding machine, designed for
repair shops and light and heavy industrial use.
power source
Supply voltage of the Kempomat 2500 power source is 3~ 230 V/400 V. Supply voltage of the
Kempomat 3200 power source is 3~ 230 V/400 V. Welding voltage adjustment is in 10-steps.
Adjustment for voltage of power source is in 40-steps.
In Kempomat 4200 product range there are different units for mains voltages 3~ 230 and 400
V. The welding voltage adjustment for 230 V power source is made in 32 steps, 400V power
source in 56-steps. The Volt/Ampere metering unit MSD 1 (available as accessory) displays
voltage or welding current.
wire feeder unit
The wire feeder unit is a fixed unit in the equipment for air-cooled guns. Kempomat 2500 is
equipped with 2 wheel wire drive mechanism, Kempomat 3200 and 4200 are equipped with
4 wheel wire drive mechanism. Accessory unit KMW sync is needed for connection and use of
push-pull guns.
notation. Read these sections carefully and follow
'NOTE!'
EN
3