Monte Carlo Fan Company 5OR52XXD-L Series Owner's Manual And Installation Manual page 6

For fan with light, go to
step 28.
For Fan without light,
go to step 35.
30
Attach light fixture to switch housing,
aligning the preassembled screws on
switch housing cover on the light fix-
ture with the L shape holes on switch
housing and turn clockwise until
tight. Re-install the screw removed in
step 28. Tighten all screws securely.
33
Attach glass to light fixture and in-
stall rubber washer and hex nut re-
moved in step 32 to secure glass.
© 2013 Monte Carlo Fan Company
28
Loosen 2 ( the 2 screws which near
the slot ) and remove one preassem-
bled screws from light fixture assem-
bly. Keep screw for later use.
31
Install 3 x 60 watt Candelabra base bulbs.
Bulbs included.
WARNING: Over lamping the fan will re-
sult in the fan lights shutting down until
the proper wattage of bulbs are installed.
Reset the lights by turning off the wall
switch, breaker,or by remote. Replace bulbs
with the correct wattage bulbs, turn the
power on.
34
Install finial cap and finial nut remove
in step 32, threading the pull chains
through each of the holes. Hand-
tighten finial nut securely.
6
29
slot
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture.
32
Remove finial nut, finial cap, hex nut,
and rubber washer from fitter.
35
Remove switch housing cap from
light fixture by removing hex nut and
lock washer.
7/1/2013