Monte Carlo Fan Company 5OR52XXD-L Series Owner's Manual And Installation Manual page 5

19
Place canopy over fan body align-
ing holes.
22
Take 4 screws from hardware pack
and insert 2 one on each side of
bracket to match the L slot screw
holes in canopy. Keep 2 screws for
later use.
25
Lift fan to mounting bracket, aligning the "L"
shape holes on the canopy with the screws on
the mounting bracket. Turn the fan clockwise
to lock in position. Re-install the screws re-
moved in the previous step and tighten se-
curely.
© 2013 Monte Carlo Fan Company
20
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
23
House
Black
White
Ground
Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to White
(Neutral) wire from house. Connect Ground leads from
mounting bracket and downrod to Ground lead from
house. Refer to Safety Tips section of manual.
26
Place blade holders onto blades aligning holes in
blade holder with holes in blade. Make sure that the
side of the blade you select is facing downward. In-
stall 3 screws and fiber washers to back side of blade
as shown. Tighten screws securely. Repeat this
process 4 more times until all blades are assembled.
5
21
Remove the all thread studs from the
lower part of the mounting bracket.
Hang fan from mounting bracket by
the hands free hook into a closed
hole on the edge of the Canopy.
Note: For Canadian mounting refer
to Step #8.
24
Fan
Blue
Black
White
Green
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
27
Install blades to motor using the 10
motor screws provided. Tighten
screws securely.
Hands free hook
7/1/2013