Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3 0 6 4 9 6 4
5LLR56XXD Series Fan
ETL Model NO. : 5LLR56(XXXXX)
RETAILER NAME:
RETAILER ADDRESS:
8 kgs
17.6 lbs
Total fan weight with light
Advertisement
Related Manuals for Monte Carlo Fan Company 5LLR56
Summary of Contents for Monte Carlo Fan Company 5LLR56
- Page 1 Owner’s Guide and Installation Manual 5LLR56XXD Series Fan ETL Model NO. : 5LLR56(XXXXX) Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 8 kgs 17.6 lbs...
-
Page 2: Cautions And Warnings
Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2014 Monte Carlo Fan Company 10/1/2014... - Page 3 Place downrod over canopy and yoke Partially loosen downrod set screws from cross pin from downrod. cover yoke at top of motor assembly. Thread lead wires and safety cable from motor assembly through downrod. © 2014 Monte Carlo Fan Company 10/1/2014...
- Page 4 Black (Live) from house to Black from remote marked AC IN L. Connect all green grounded wires to Grounded wire from House. Make sure that no filaments are outside of the wire connectors. Insert the remote receiver into mounting bracket. © 2014 Monte Carlo Fan Company 10/1/2014...
-
Page 5: Flush Mount Installation
Note : If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The Outlet Box. © 2014 Monte Carlo Fan Company 10/1/2014... - Page 6 18 and tighten all securely. Repeat this process for screws securely. remaining blades. Install the blade assembly to motor using the set screws provided. Tighten screws securely Repeat this process for remaining blade assemblies. © 2014 Monte Carlo Fan Company 10/1/2014...
- Page 7 fixture and attach it with the preassembled set screws on onto light fixture by turning clockwise till light plate and twist clockwise until lock. tight. Reinstall the screw removed in step 23. Tighten all screws securely. © 2014 Monte Carlo Fan Company 10/1/2014...
-
Page 8: Transmitter Operation
Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2014 Monte Carlo Fan Company 10/1/2014... - Page 9 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2014 Monte Carlo Fan Company 10/1/2014...
-
Page 10: Troubleshooting
Trouble Shooting Warning Trouble Suggested Remedy CAUTION CAUTION CAUTION © 2014 Monte Carlo Fan Company 10/1/2014... - Page 11 Oct.2014...