Hob - Helpful Hints And Tips - Zanussi ZCG667 User Manual

1. Turn the knob to the maximum position
and push it down. When you push the
knob, the spark generator activates auto-
matically.
2. Keep the control knob pushed for approxi-
mately 5 seconds. This lets the thermocou-
ple warm up. If not, the gas supply is inter-
rupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
the correct positions.
8
7
6
5
Burner cap
1
Burner crown
2
Ignition candle
3
Thermocouple
4
Slots
5
Burner body
6
Location peg
7
Hole
8
Replacing burner parts
1. Carefully put the burner crown on the
burner body. Do not use force.

Hob - Helpful hints and tips

Warning! Refer to "Safety information"
chapter.
Energy savings
• If possible, always put the lids on the pans.
www.zanussi.com
2. Put the burner cap centrally on top of the
3. Try to light the burner. If the burner does
1
If the burner does not light after 15 seconds,
2
release the control knob, turn it into off position
and wait for at least 1 minute before trying to
light the burner again.
3
Turning the burner off
4
To put the flame out, turn the knob to the sym-
bol
from the burner.
Lid Safety Device
Lid has safety device, which cut off gas supply
for hob. It works only when lid is closed.
cut-off device.
• When the liquid starts to boil, turn down the
flame to barely simmer the liquid.
a) Make sure that the hole in the crown is
above the ignition candle.
b) Make sure that the location pegs are in
the slots in the burner body.
c) Let the crown fall freely onto the body.
d) Make sure that you can move the
crown a small distance from side to
side.
crown (enamel side up). Move the cap from
side to side and front to back to make sure
that it is correctly installed.
not ignite, adjust the crown and cap again.
Warning! Do not keep control knob
pressed for more than 15 seconds.
.
Warning! Always turn the flame down or
switch it off before you remove the pans
Warning! Always use the control knob to
switch off a burner. Do not use the lid as a
7