Anti-Tip Receiver; G.armrest Receiver Attachment; H.padded Swing Away Armrest - Quickie Q7 Adjustable Owner's Manual

E NG LIS H
2. Ergo Scissor Wheel Locks or Compact Wheel Locks
a. Using a 4mm Allen wrench, turn one of the screws
(A) in the clamp counterclockwise one-quarter turn.
b. Repeat the same process with the remaining three screws (A).
c. Alternately loosen the screws (two turns each) until both screws are loose.
d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to prevent
wheel movement, when in the locked position.
e. Adjust angle position.
f. Tighten screws to 62 in-lbs. (7 Nm).
NOTE– Clamp and wheel lock may need to be rotated to clear frame tubing.
F. ANTI-TIP RECEIVER
Sunrise Medical recommends anti-tip tubes for all wheelchairs.
a. After attaching the Anti-tip receiver (B) make sure that the receiver is parrallel with the
ground, and the bolts are tightened so that the anti-tips don't move when used.
G. ARMREST RECEIVER ATTACHMENT
Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver (C):
1. Loosen the four receiver adjustment bolts (D) on the sides of the receiver.
2. With the armrest in the receiver (C), squeeze the receiver to achieve the desired fit.
3. Tighten the four bolts (D). (144 in-lbs, 16.3 Nm)
26
Position Adjustment
1. Loosen the two clamp bolts (E) until clamp is loose.
2. Slide armrest receiver to desired position.
3. Tighten both (E)(F) bolts to 62 in.-lbs. (7 Nm).
H. PADDED SWING-AWAY ARMRESTS (OPTION)
Swing-away armrests can be detached or can swing away to allow lateral transfers. They are height
adjustable (6" in 1" increments) by moving bolts (G) up or down in predrilled holes on armrest
bracket.
Swing-away, angle adjustable
To change the angle, remove bolts (G), reposition to needed angle. Reinsert bolt and tighten.
22
23
24 25
27
IX. DEALER SERVICE AND ADJUSTMENT
27
19
22
23
24
26
F
E
27
G
112786 Rev. F