Assembly:; Anti-Tip Wheels; Kerb Climber - Quickie F35 R2 Instructions For Use Manual

5.0 Assembly:

5.1 Footplates
The footplates can be
flipped up to make it easier
to transfer to/from the chair.
Lower leg length:
For users with longer legs,
the leg support can be
lowered to the appropriate
level by using the screws
(1). Loosen the screws, push
the tubes to the desired
position and then re-tighten
the screws (see section on
torque). There must always be a minimum gap of 25mm
between the footplates and the ground, (Fig. 8.0).
Footrests and Latch
The legrests can be swung inwards under the seat sling
or outwards.
When fitting the legrests, the footrests must be pointing
inwards or outwards. Then rotate the legrest inwards, until
it locks into place. To remove, pull the lever (2), swing the
footplate inwards or outwards and then lift the legrest out.
Make sure that the legrest is locked into place correctly.
CAUTION!
• The legrests must not be used to lift or to carry the
wheelchair.
• When getting on or off the wheelchair, do not use the
footboards.
These should be flipped up beforehand or the footrest
should be swung to the outside as far as possible.
12
Quickie F35 R2 Rev.E
Fig. 5.0
2
1
5.2. Anti-tip wheels (Fig.5.1):
The anti-tip tube is fixed to the frame tube by a mounting
pin.
To fit the anti-tip wheels:
• Slide the anti-tip tube through the hole located on top
of the motor.
• Align the holes in the anti-tip and frame tube.
• Insert the mounting pin.
• Repeat for the other side.
• Reverse the procedure for disassembling.
NOTE: Anti-tips wheels may interfere with kerbs when
mounting or dismounting. Follow the instructions in
sections 6.13 & 6.14.
WARNING!
Never use the wheelchair without the anti-tip wheels
fitted.
Fig.5.1
5.3. Kerb climber (Fig. 5.2):
• Fit the oval connecting clamps over each lower
frame tube and loosely tighten the studs, (1), using a
5.0 mm. Allen key.
• Insert the support brackets, (2), into each clamp.
• Fit the kerb climber into the supports.
• Insert the fastening clip, (3), through the holes in the
kerb climber tube and support brackets.
• Tighten the studs fully, (1).
Fig.5.2
1
2
3