Client Data Usage - Cradlepoint COR IBR350 Manual

Condition
Value
Port
is
USB Port 1
Type
is not
WiMAX
• When:
– Port – Select by the physical port on the router that you are plugging the modem into (e.g., "USB Port 2").
– Manufacturer – Select by the modem manufacturer, such as Sierra Wireless.
– Model – Set your rule according to the specific model of modem.
– Type – Select by type of Internet source (Ethernet, LTE, Modem, Wireless as WAN, WiMAX).
– Serial Number – Select 3G or LTE modem by the serial number.
– MAC Address – Select WiMAX modem by MAC Address.
– Unique ID – Select by ID. This is generated by the router and displayed when the device is connected to the router.
• Condition: Select "is," "is not," "starts with," "contains," or "ends with" to create your condition's statement.
• Value: If the correct values are available, select from the dropdown list. You may need to manually input the value.
Once you have established the condition for your configuration rule, choose from the other tabs to set the desired configuration. All of the tabs
have the same configuration options shown above in the WAN Configuration section (i.e., the options for Configuration Rules are the same as they
are for individual devices).
Client Data Usage
Client Data Usage displays upload and download traffic for each LAN client. Click Enable Client Data Usage Monitoring Service to begin tracking
this information. This data is not retained between router reboots.
For each client this shows: Name, IP address, MAC address, amount of data uploaded (MB), amount of data downloaded (MB), and when traffic
was last sent or received for that client ("Last Traffic").
The names that are shown are received during a DHCP exchange. If a client disconnects and reconnects with a new IP address there will be an
additional entry in this list.
Pressing Reset Statistics will restart all counters at 0.
Figure 120: Client Data Usage
94