Cradlepoint COR IBR350 Manual page 67

Schedule Set up a schedule for this network interface. This allows an interface to be enabled or disabled during specific hours of a day. For
example, use this to limit a Hotspot network to business hours.
Schedule Service: (Default: Disabled.) Select to enable. This will open a configurable chart for setting the schedule.
Each hour of the week is represented by a black or gray square. Black represents disabled, while gray represents enabled. Hover over a square to
reveal the hour it represents. Click on the squares to toggle between black and gray.
In the example shown, the network is enabled from 8-5 on Monday through Friday, but disabled at all other times.
Wired 802.1X Wired 802.1X: (requires hardware version 2.0) This allows you to configure an authentication server that will accept authentication
requests from devices attached to wired Ethernet ports. IEEE 802.1X defines the encapsulations of the Extensible Authentication Protocol (EAP).
Click Enable 802.1X to require IEEE 802.1X authorization for the Ethernet ports associated with this network.
Reauthentication Period: EAP re-authentication period in seconds.
Authentication settings
• Auth Server IP Address: This is the IP address of the connected RADIUS server.
• Auth Server MAC Address: This is the hardware address of the connected RADIUS server's interface. NOTE: If you don't know the MAC
address for the RADIUS server, enter 00:00:00:00:00:00 and the service will try to find the MAC address from the given IP address.
• Port: 1812 is common for the authentication port.
• Password: Assigned by the RADIUS server.
Accounting settings: Most of the accounting settings often match the authentication settings, depending on whether the RADIUS server is the
same for both authentication and accounting.
• Acct Server IP Address
• Acct Server MAC Address
• Port: 1813 is common for the accounting port.
• Password
Figure 85: Network Interface Scheduler
67