Update
Modem
Firmware Click on the Firmware button to open the Modem Firmware Upgrade window. This will show whether there is new
modem firmware available.
If you select Automatic
(Internet) the firmware will be updated automatically. Use Manual
Firmware
Upgrade to instead manually upload firmware
from a local computer or device.
Reset
the
Modem Click on the Reset button to power cycle the modem. This will have the same effect as unplugging the modem.
Configuration
Rules
(Advanced)
This section allows you to create general rules that apply to the Internet connections of a particular type. These can be general or very specific. For
example, you could create a rule that applies to all 3G/4G modems, or a rule that only applies to an Internet source with a particular MAC address.
The Configuration Rules list shows all rules that you have created, as well as all of the default rules. These are listed in the order they will be applied.
The most general rules are listed at the top, and the most specific rules are at the bottom. The router goes down the list and applies all rules that
fit for attached Internet sources. Configuration settings farther down the list will override previous settings.
Select any of these rules and click "Edit" to change the settings for a rule. To create a new rule, click "Add."
WAN Configuration
Rule
Editor After clicking "Add" or "Edit," you will see a popup with the following tabs: