Table of Contents
Advertisement
3 SHIPPING, HANDLING, STORAGE
3.1 Storage
The generating set is protected during shipping
by suitable packaging. It must be stored horizon-
tally, in a covered, dry and ventilated area.
Do not turn the package
upside down. The right way up is the one
shown by the symbol printed on the packag-
ing (
).
3.2 Weight
Total weight including packing:
ENERGY 4004 D 98 kg
3.3 Handling
The generating set, complete with packaging,
can be moved using common lifting and transport
equipment.
The boxes are provided with spacers in order to
allow for the introduction of transpallet forks.
port, comply with accident prevention and
safety regulations. Use lifting and transport
equipment with a capacity greater than the
load to be lifted.
Vers. 007
During lifting and trans-
Energy 4004 D
GB
4 INSTALLATION
4.1 Preliminary information
ating set, it is essential to read these instruc-
tions, in order to avoid errors during installa-
tion.
stalled so as to prevent water seeping directly
into the alternator through the inlet holes; it
must therefore be protected.
Improper installation of the generating sets
can cause irreparable damage to the equip-
ment and compromise the safety of the instal-
lation engineer, and invalidate guarrantee
Should the generating sets be installed in a man-
ner which does not comply with the instructions
in this manual, the Manufacturer shall be held
blameless for malfunctions or for the safety of the
generating set, under D.M. 89/392/EEC. Fur-
thermore, he shall be held blameless for any da-
mage or injury to persons or things.
formed by qualified and properly trained per-
sonnel only.
4.2 Installing the generating set
The ENERGY 4004 D energy set is provided with
anchoring brackets extra vibration dampers (Fig.
4, Ref. 1) and a fuel filter to be fitted in the fuel
line. The brackets are designed for hanging as-
sembly.
This kind of assembly provides the following ad-
vantages: less room taken up, quick installation,
easy access for routine and unscheduled main-
tenance.
Make sure that there is enough space around the
hood of the generating set to allow cooling air to
pass; also leave 20 mm free space between the
hood and the surrounding parts.
Should the generating set air intake be behind a
wheel of the vehicle, care should be taken to
prevent water from being sprayed into the gener-
ating set.
4
Before installing the gener-
The generator must be in-
Installation must be per-
7
Hide quick links:
Advertisement
Table of Contents
