Table of Contents
Advertisement
3 SHIPPING, HANDLING, STORAGE
3.1 Storage
The generating set is protected during transport
by suitable carton packaging and a wooden
base. It must be stored horizontally, in a covered,
dry and ventilated area.
upside down. The correct position is the one
shown by the symbol printed on the package
(
)
3.2 Weight
Total weight including packing:
ENERGY 2510D 90 kg
3.3 Handling
The
generating
sets,
packaging, can be handled using common lifting
and transport equipment.
The boxes are provided with spacers in order to
allow for the introduction of transpallet forks.
transport, comply with accident prevention
and
safety
regulations.
transport equipment with a capacity greater
than the load to be lifted.
Vers. 001
Do not turn the package
complete
with
During
lifting
Use
lifting
Energy 2510 D
GB
4 INSTALLATION
4.1 Preliminary information
generating set, it is absolutely necessary to
read these instructions to prevent any
installation errors.
installed so as to prevent water seeping
directly into the alternator through the air
inlets; it must therefore be protected.
Incorrect installation of generating sets can
cause irreparable damage to the equipment
and endanger the safety of users.
Should the generating sets be installed not in
compliance with the instructions in this manual,
the Manufacturer shall not be held responsible
for malfunctioning or for the safety of the
generating set, by the terms of the Italian Law
their
Decree D.M. 89/392/EEC. The Manufacturer
shall also not be liable for any injury or damage
to people or property.
performed by skilled and adequately trained
and
personnel only.
and
4.2 Instructions for fastening the generating
set
The ENERGY 2510D generating sets are
provided with anchoring brackets with extra
vibration dampers (fig. 4, ref. 1) and a fuel filter
(fig. 4 ref. 2) to be fitted along the generator
feeding pipe. The brackets allow for hanging
assembly. The brackets allow for hanging and
floor assembly. This kind of assembly provides
the following advantages: less room taken up,
quick installation, easy access for routine and
unscheduled maintenance.
Make sure that there is enough room around the
hood of the generating set to let cooling air
through; also leave 10 cm free room between the
hood and the surrounding parts.
Should the generating set air intake be behind a
wheel of the vehicle, care should be taken to
prevent water from being sprayed into the
generating set by the wheel when raining.
Before
installing
The generator must be
Installation
must
the
be
7
Advertisement
Table of Contents
