Display Section; Information Display - Sony SRW-5100 Operation Manual

• This unit is out of synchronization with the external
reference video signal.
You can change the setting of the VTR SETUP menu item
102 "REFERENCE SYSTEM ALARM" so that the STOP
button will not flash in these cases.

4 Display section

1 Information display

3 SERVO indicator
4 REC INHIBIT indicator
a Information display
The information display shows a number of different
pages. To change the page displayed, with no other items
selected in the menu display (HOME, TC, VIDEO,
AUDIO, PF1, and PF2), turn the MULTI CONTROL knob
while holding it down.
The currently selected page number also appears at the
upper right of the information display.
Page 1: System status
SYS: Shows the system information (signal standard and
tape format).
PB: Shows the information recorded on the tape (signal
standard and tape format) while being played back.
FC: Shows the converted signal standard when an HKSR-
5001 board is installed.
TC: Shows the time code.
Page 2: System status
ACTIVE LINE: Shows the status of 1080/1035
conversion active line.
1080t1080
1035t1080(PANEL)
1035t1080(CONV): Shows the current conversion
status.
- - - - -: Cannot be converted.
OFF: No conversion done.
DOWN CONV. OUTPUT: Shows the output status of the
down converter.
ACTIVE: Output.
MUTING: No output.
EOS: Appears at the location of the time code for the valid
end of the previous recording.
20
2-1 Control Panel
Page 3: Phase (OUTPUT)
HD SDI OUTPUT ADV.: Shows the phase of the main
DOWN CONV. OUTPUT ADV.: Shows the phase of the
Page 4: Phase (AUDIO)
2 REF SYNC indicators
AUDIO PB OUTPUT ADV.: Shows the phase of the
AES/EBU & MONITOR OUTPUT: Shows the phase of
Page 5: Phase (TC)
LTC OUTPUT: Shows the phase of the output LTC.
Page 6: Meta Data
META DATA LINE(OUT): Shows the status of the three
META DATA LINE(FC): Shows the status of the three
META DATA LINE(SD): Shows the status of the three
The ACTIVE LINE setting displayed on page 2 can be
made in the SYSTEM menu under the OTHERS CHECK
menu in the MAINTENANCE menu. The phase settings
displayed on pages 3 to 5 and the settings relating to meta
data displayed on page 6 can be made in the PHASE SET/
META DATA menu under the ALT+OTHERS CHECK
menu in the MAINTENANCE menu.
For details, refer to the Installation Manual.
b REF SYNC (reference signal) indicators
These indicate the signal selected as the reference signal.
If there is no reference signal input to the selected
connector, the STOP button flashes.
line HD SDI output.
OFF: In phase with reference.
–90H: 90H (HD) advanced with respect to reference.
down converter output.
OFF: In phase with reference.
–2H: 2H (SD) advanced with respect to reference.
audio output signal.
OFF: Output in phase with the video output signal.
–1Frame: Output one frame advanced with respect to
the video output signal.
the AES/EBU and MONITOR AUDIO outputs.
REF: Output in phase with reference.
FC: In phase with the FC output.
–90H(HD): 90H (HD) advanced with respect to
reference.
–2H(SD): 2H (SD) advanced with respect to
reference.
LINE: Output in phase with the main line HD SDI
output.
FC: Output in phase with the FC output.
lines of main HD SDI output into which metadata is
multiplexed.
lines of output from the optional HKSR-5001 format
converter board into which metadata is multiplexed.
lines of SD SDI output into which metadata is
multiplexed.
Note