Editing Control Section; In/Out Buttons; Cursor Buttons - Sony SRW-5100 Operation Manual

2 Editing control section

1 Numeric buttons and +/– buttons
2 SFT button
3 RCL button
4 CLR button
5 SET button

6 Cursor buttons

7 ENTRY button

8 IN/OUT buttons

a Numeric buttons and +/– buttons
Press to input time data or edit points data at the cursor
position in menu display. Press buttons 0 to 5 while
holding down the SFT button to input hexadecimal A to F
for user bits. Use the +/– buttons to increase or decrease
settings.
b SFT (shift) button
Press buttons 0 to 5 while holding down this button to
input hexadecimal A to F for user bits.
Use also in combination with other buttons to perform
other operations.
c RCL (recall) button
Press to recall the previous setting, etc.
d CLR (clear) button
Press to clear input data.
e SET button
Press to finalize input data.
f Cursor buttons
Use to move the cursor (shown in reverse video) on the
display. Also use to change menu settings.
g ENTRY button
Press to enter an edit or cue point.
While holding down this button, press either the IN or
OUT button.
h IN/OUT buttons
To set a IN or OUT point during editing, press either of
these buttons while holding down the ENTRY button.
While editing by connecting this unit to a recorder, press
the IN or OUT button while holding down the SFT button
and the CLR button to delete the AUDIO IN or AUDIO
OUT point that is set by an external device.
3 Tape transport control section
1 STANDBY button
2 PREROLL button
5 PLAY button
6 STOP button
a STANDBY button
Press this button in other than standby mode to make it
light up and place this unit in standby mode. The head
drum rotates in standby mode, thereby shortening the time
required for the tape to start.
Press this button while in standby mode to turn the button
off and exit from standby mode. The head drum stops
rotating and the tape tension is released. If this unit
remains in standby mode for more than eight minutes
(factory setting), standby mode is automatically canceled
in order to safeguard the tape.
b PREROLL button
Press to run the tape to the preroll point (a position factory
set to five seconds before the IN point).
Press this button while holding down the IN or OUT button
to cue up the tape at the IN or OUT point.
For details on changing the preroll time, see "4-2-3
Setting the Preroll Time (PREROLL TIME)" on page 49.
c PLAY button
Press to start playback.
d STOP button
Press this button to stop playback.
When you insert the cassette, this unit automatically enters
STBY OFF mode.
The STOP button flashes in the following cases.
• There is no external reference video signal.
19
2-1 Control Panel