Synopsis - intervolt DCC Pro Installation & Operation Manual

Synopsis

As an autonomous device the DCC Pro is capable of charging and maintaining
di erent battery types according to the speci c chemistry. This ensures the
battery is charged and maintained correctly resulting in greater performance
and longer life.
The DCC Pro is pre-programmed with charging regimes available for a variety of
battery types which can be selected in the con guration (set-up) process:
• Standard Lead Acid – sealed and ooded cell versions
• Absorbed Glass Mat – aka AGM
• Geli ed Electrolyte – aka GEL
• Lead Calcium
In addition to the above there is also a constant voltage supply setting of 13.2V
which can be used as a ' oat' only charging source. This can be utilised where
the battery being charged is not cycled but is used as a back-up or support
source such as a security system for example.
Although the DCC Pro utilises the vehicle's main battery as the primary charging
source it is also fully solar enabled. A dedicated input is provided for direct
connection to any compatible solar panel without the need for a separate
regulator. The solar charging function uses sophisticated algorithms for
maximum power point tracking (MPPT) to capitalise on any available solar
power and optimise the charging process.
With ability to be voltage or ignition controlled, the DCC Pro has the exibility to
adapt to almost any application. Furthermore, the ignition control function
allows for selection of normal or low ignition input to cater for traditional or ECU
controlled electrical systems.
The information on the following pages details the functions of the DCC Pro and
the settings which are best for your application/installation.
NOTE: It is not essential to use the Remote Display included. The DCC Pro is
a standalone device and will operate with or without the Remote Display
connected. It is necessary to use the Remote Display for programming
purposes, that is, selecting battery type and control mode, however it is
not necessary to permanently install the display if it is not required.
5