Chroma Color Force 72 User Manual page 8

13
When DMX is Lost
If DMX is not detected various output options can be selected:
Press Up/Down to access "When DMX is Lost", press Enter, press Up/Down buttons
to select the setting , press Enter for 2 seconds to save.
'Off' - will snap to off
'Hold' - will hold the last valid DMX state
Look 1-31 will snap to the Look of your choice
Look Store
The Color Force has 31 internal preset FX Looks for stand-alone operation, 1-23 are
pre-programmed.
To replay a Look in stand-alone operation, press Up/Down buttons to access "Look
Store", press Enter, press Up/Down buttons to select the desired Look and press
Enter for 2 seconds to save settings.
To replay a Look with a DMX console, press Up/Down buttons to access Control
Mode 11 and press Enter for 2 seconds. Use the DMX console with the assigned
channel to playback the various looks stored. (1-31 looks in 1 single channel)
Note: DMX has priority over internal Looks.
Looks can be recorded to the internal flash memory by users and will be preserved
on power down. However, looks will be returned to default setting if Reset is
performed. There are two ways to record a look:
Simple, with DMX console.
Set the Color Force to the desired Control Mode. Use a DMX console to adjust
channel levels and create the desired look or effect. Press Up/Down buttons to "Look
Store" and press Enter, press Up/Down buttons to the desired Look number and
press Enter. Press Enter again for 2 seconds to save Look.
Advanced, stand-alone. (DMX is unplugged)
Press Up/Down buttons to access "Look Store", and press Enter, press Up/Down
button to the desired Look and press Enter to access the memory data. The data is
presented as two numbers separated by a letter "c". The number to the left of the "c"
is the channel number and to the right is the channel level. Pressing Up/Down up to
the far end will show the Mode at which the selected Look was programmed.
To edit the Mode of a selected Look:
Press Up/Down buttons to access "Look Store" and press Enter, press Up/Down to
the desired Look and press Enter to access the memory data. Press Up/Down
buttons up to the far end until Mode number is shown and press Enter. Press
Up/Down buttons to adjust the Mode number. Press Enter to toggle back to the
channel numbers.
To edit the channel numbers and levels of a selected Look:
Press Up/Down buttons to access "Look Store" and press Enter, press Up/Down to
the desired Look and press Enter to access the memory data. Press Up/Down
buttons and select the channel number. To edit the channel level, press Enter and
use the Up/Down buttons to adjust the level (shown as 0-255). Press Enter to toggle
back to the channel number. When the desired effect is created press Enter for 2
seconds to save the edited Look.
Color Force User Manual
Slave stand-alone
7 V2.0 October 2011