Yeti Cycles ASRC Owner's Manual page 12

ASSEMBLY
13.
Use a Fox guide pin to align the link, spacers and
the swingarm.
15.
pull the lower link guide pin back, leaving it
partially in place. Give yourself clearance for the
rear of the shock to slide into place. Place the
shock into the link and reinsert the guide pin.
24.
14.
Slip the front shock mount into the front triangle
and use another Fox guide pin to align and hold
it in place.
16.
Using the guide pin, slide the lower link pivot
hardware through the swingarm, link and shock.
Use a soft mallet to tap it through if necessary.
17.
Using the guide pin slide the front shock
mounting hardware through the frame and shock.
Use a soft mallet to tap it through if necessary.
19.
Using a well calibrated torque, wrench tighten the
lower link hardware to 6.5 Nm.
Torque to 6.5 Nm
ASSEMBLY
18.
Apply blue (248) Loctite to the male bolts for the
shock mount and the lower link pivot at this time.
20.
Using a well calibrated torque, wrench tighten the
front shock mounting hardware to 6.5 Nm.
Torque to 6.5 Nm
25.