Replace The Lens - ACME DELUGE LED-WAV-50W User Manual

(000-2555,clockwise/counterclockwise), or
to confirm and use DOWN and UP button to adjust the value, once select press ENTER
button to setup or automatically exit menu mode without any change after one minute. To go
back to the last function without any change press the MENU button.
Self-test
Press the MENU button up to when the
button to run the auto test. Back to the functions without any change press MENU button.
Back to the functions without any change press MENU button.
Temperature Test
Press the MENU button up to when the
button and the display will show the temperature of the unit. To go back to the functions
press the MENU button again.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.
Factory reset all channels
Press the MENU button up to when the
button to setup. Back to the functions without any change press MENU button.
(125-255),press ENTER button
is shown on the display, Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is showing on the display. Pressing ENTER
is shown on the display, press ENTER
9A
○
4 Only for remote control: Connecting with CA-8/UC3 to control the unit for
Stand by, Function and Mode function
○
5 DMX output: For DMX512 link, use 3-pin XLR plug cable to link the next unit
○
6 DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal
○
7 Mains input: Connect to supply mains power for the unit
○
8 Mains output: Connect and supply mains power for the other unit
○
9 Cooling system: for cooling down the unit
3.2 Installation
A. Product Items
User manual
60°lens
B. Mounting
You can install the unit on the truss or ceiling; Use clamps to fix the unit to truss. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure. Also always use a
safety cable that can hold 10 times of the weight of the unit when installing the fixture.
C. Replace the lens
You could replace the other lens if you want to, as following picture.
You should screw the lens roller to take it down as NO.1, and bring the lens out as No.2.
Then you could replace the lens that you want to.
Notes: the lens roller has two slots for the lens; you should pay more attention that the latest
slot is for the 34°lens, and the far slot is for 60°lens.
6A