VeriFone NURIT 8000 Installation Manual page 16

S
ETUP
Installing SIM, SAM, and SD Cards
CAUTION
To remove a SIM/SAM
card
To install an SD/MMC
card
16
NURIT 8000 I
NSTALLATION
7
Lower the SIM/SAM cardholder onto its base.
Check that the corner of the SIM/SAM card is not obstructed by the triangular
protrusion at the corner of the cardholder base.
8
Lock the SAM cardholder by sliding the cardholder locking clasp to the
position.
Do not bend or scratch the contacts of the SAM cardholder when installing or
removing cards.
9
If necessary, replace the battery. See
10
Replace the battery/card compartment cover. See
Figure 6 Installing and Removing a SIM/SAM Card
1
Open the card holder, by following
SAM card and remove the card.
2
Close the card holder by following
SAM card.
For further instructions, see
1
Remove the battery/card compartment door. See
2
If necessary, remove the battery. See
3
Hold the SD/MMC card directly above the SD/MMC card slot, with the metal
contacts facing down and the narrow edge with the beveled corner pointing
towards the slot opening.
4
Lower the SD/MMC card into position.
G
UIDE
Figure 9.
Step 1 to Step 4
Step 7 to Step 8
Figure 6.
Figure 10.
LOCK
Figure 5.
of To install a SIM or a
of To install a SIM or a
Figure 4.