Important Note - Titan SF290E Safety And Operating Manual

ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR SANDER
1. Never use this sander for wet sanding or liquid polishing. Failure to follow this rule
may result in risk of electrical shock.
2. Always wear eye protectors when using this sander.
3. Always wear a dust mask when using this sander.
4. Always inspect and remove all nails and screws etc from lumber before sanding.
5. Always check walls and ceiling to avoid hidden power cables and pipes. A metal
detector can be obtained from any good DIY store for this purpose.
6. If possible, ensure the workpiece is firmly clamped to prevent movement.
7. Your sander is a hand held tool, do not clamp your finishing sander.
8. Never stop the sander by applying a force to the base plate.
9. Only use sanding paper in good condition. Do not use torn or worn sanding paper.
10. Do not sand magnesium material due to the risk of fire.
11. Do not sand material including asbestos due to a health rise.
12. Do not sand lead based paint due to the rise of lead poisoning.
13. Do not eat or drink in the working area of the sander.
14. Do not allow people to enter the working area without wearing a dust mask.
15. Where possible, seal off the working area to contain the dust for later removal.
WARNING!Some dust particles created by power sanding, sawing, grinding,
drilling and other construction jobs contain chemicals known to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
Lead from lead-based paints.
Crystalline silica from bricks and cement and other masonry products.
Arsenic and chromium from chemically treated lumber.
Your risk form these exposures varies, depending upon how often you do this type of
work.To reduce your exposure to these chemicals:
Work in a well ventilated area.
Work with approved safety equipment, such as those dust masks that specially designed
to filter out microscopic particles and use the dust bag at all times.
Double insulation:
The tool is double insulated.This means that all the external metal parts are electrically
insulated from the mains power supply. This is done by placing insulation barriers
between the electrical and mechanical components making it unnecessary for the tool
to be earthed.

Important note

Be sure the supply is the same as the voltage given on the rating plate.The tool is fitted
with a two-core cable and plug.
Remove the mains plug from socket before carrying out, any adjustment or servicing.
1/2 SHEET SANDER SF290E