Operation Instructions - Titan SF290E Safety And Operating Manual

OPERATION INSTRUCTIONS

Warning! Before using your sander be
sure to read the instruction manual
carefully.
1. FITTING THE SANDING PAPER (See Fig2,
3, 4)
Fit the sanding paper over the base. Make sure
the sanding paper is even with the edges and that
the dust collection holes in the base and sanding
paper is aligned and that the sanding paper is
taut on the base.
Lift the sanding paper retaining clips to the open
position and insert one end of the sanding paper
under the retaining clip.
Push the clip back into the retaining position.
Lightly stretch the paper over the base plate
ensuring that it is not folded or wrinkled then
position under the other retaining clip back into
the retaining position. Check that the paper is flat
to the base plate, if not, release either clip and
reposition the paper before resetting the clip.
Switch on momentarily to check that the sander is
functioning correctly. If there is undue vibration,
repeat the paper positioning procedure.
2. PUNCH THE HOLE
After fitting the sanding paper as shown in fig5,
put the hole punch on the sanding paper aline the
sanding base edges as shown in fig6.Then press
it forcibly (see fig7 & 8)
3. DUST COLLECTION BAG (See Fig9)
Your sander is equipped with a dust collection
bag. To attach, insert the Dust collection bag into
the back of the sander in correct position. Then
o
turn the bag to 90
make sure the bag is tightened securely on the
dust extraction nozzle.
4. ATTACHING SANDER TO VACUUM (See
Fig10)
Your sander is equipped with a dust extraction
adapter, which is designed for collect dust task.
Insert the dust adapter (not supplied) into the rear
dust outlet of sander. Then pull the dust adapter
and make sure it is tightened securely on the
dust outlet. Then connect the hose of a vacuum
cleaner.
First please turn on the vacuum cleaner, then turn
1/2 SHEET SANDER
clockwise. Pull the bag and
Fig 2
Fig 3
Fig 4
Fig 5
SF290E