Advertisement
1. Press bearing assemblies out of HD swingarm
using an appropriate press collar or socket. Re-
fer to HD service manual for proper procedures.
2. Press bearings into Lehman swingarm. Bearings
should bottom out inside swingarm collar.
NOTE: Make sure there is no dirt or powder coat
material in the bearing bore where the bearing
needs to seat. See Fig. 1.
3. See Fig. 2. Remove top and center bolts from
rear primary cover and drill out to 1/4".
4. See Fig. 3. Install LH transmission brace behind
primary cover. Install using Loctite 242 with 1/4"
x 2-3/4" bolts and flat washers into top hole and
1/4" x 2-1/2" bolt and flat washer into lower hole.
Both bolts will thread into bracket. Torque to
110 inch lbs.
•
(1) LH Transmission Brace– LB6421
•
(1) 1/4" x 2-3/4"Socket Bolts- CB1122
•
(1) 1/4" x 2-1/2" Socket Bolts CB1116
•
(1)
6.4 X 1.6 Flat Washers-
SWINGARM INSTALLATION
CW2160
9
Fig. 1
Fig. 2
Drill out top 2
holes
Fig. 3
2014+ XL Raider
Advertisement
