Advertisement
1. See Fig. 1. Attach brass block to swingarm
using the following hardware. Insert spacer
under brass block.
•
(1) Brass Block– S002123
•
(1) 1/4" x 3/4" Bolt– CB1100
•
(1) 1/4" Flat Washer- CW2005
•
(1) Spacer– S001530
2. Attach brake lines and residual valve to brass
tee. Torque valve to 11 ft-lbs.
•
(2) Brake Lines– S001976
•
(1) Residual Valve- S002037
•
(1) Banjo Washer– GC6002
3. See Fig. 2. Route OEM line above swingarm
to residual valve as shown. Secure brake line
to swingarm with cable tie.
4. See Fig. 2. Install OEM Brake line to residual
valve using the following hardware. Torque
banjo bolt to 16 ft-lbs.
•
(1) M10 Banjo Bolt– CB6001
•
(2) Banjo Washers– GC6002
BRAKE INSTALLATION
16
Fig. 1
Fig. 2
2014+ XL Raider
Advertisement
