Advertisement
1. See Fig. 1. Once body is in place and
secure, install support bracket to motorcy-
cle frame using the following hardware.
•
(1) Support Bracket- S001942
•
(1) 5/16" x 1-1/2" Bolt– CB1170
•
(2) 5/16" Flat Washers– CW2010
•
(1) 5/16" Lock Nut– CN3045
•
(1) 1/4" U-Bolt– CB6201
•
(2) 1/4" Flat Washers– CW2005
•
(2) 1/4" Lock Nuts– CN3040
2. See Fig. 2. Grab handles will be installed
on body, next to passenger section of
seat.
3. Evenly locate grab handles on body and
mark for drilling. Drill holes using 1/4" drill
bit.
CAUTION: Make sure LH rear hole does
not interfere with front trunk wall when lo-
cating handles.
4. Place rubber standoff (S001701) between
grab handle and body.
5. Install grab handles to body using the
following hardware.
•
(2) Grab Handles– S001035
•
(4) 5/16" x 1" Socket Bolts- CB1159
•
(4) 5/16" Lock Washers– CW2047
•
(4) 5/16" Fender Washers–CW2109
GRAB HANDLE INSTALLATION
Front of trike
Even spacing from
center of body
32
Fig. 1
Attach support
bracket to frame
and top support
Fig. 2
2014+ XL Raider
Advertisement
