Installing Lehman Swingarm - lehman Trikes DYNA Installation Instructions Manual

Installing Lehman Swingarm

Note: Provided they are in good working order, all original components of Harley-Davidson
swingarm may be re-used.
1. Clean and inspect original components, replace if necessary.
2. See Fig. 1. Install components into Lehman swingarm in same orientation as original swingarm.
3. Install motor mount braces (LB6111) and aluminum
spacers. Long spacer (LS6126) will go on RH side and
short spacer (LS6125) will go on LH side.
4. See Fig. 2. Fasten transmission brace and spacers with
supplied (CB1270) GR. 8 bolts and (CN3053) stake nuts.
Using Loctite 262 install bolt with head on RH side of
motorcycle. Torque to 33 ft. lbs.
5. Use new pivot shaft bolt (LP6105) to align brace plates.
The pivot bolt should be free to rotate or pull out when
locknuts are tight.
Fig. 1
6
Fig. 2 LB6111
Motor Mount
Brace
(RH Side)
LB6111 Brace- LH Side
2006-2013 FXD Renegade Rev. 6