Battery Screen; Figure 21 Battery Screen - Outback FXR2012A Operator's Manual

Metering

Load displays kilowatts and AC amperage consumed by devices on the inverter's output. It can be the same
Invert
as .

Buy displays the kilowatts and AC amperage brought into the inverter's input for both charging and loads.
This is usually a total of

Battery displays the uncompensated battery voltage.

AC Out displays the AC voltage measured at the inverter's output. If an AC source is present, this reading is
AC In
usually the same as

AC In displays the AC voltage measured at the inverter's input from an AC source. This number may be
erratic or inaccurate upon first connection until the inverter synchronizes with the input source.

AUX displays the current status of the inverter's Auxiliary (AUX) 12-volt output. (See page 50.)

A diode symbol may appear to the left of the screen name to indicate "diode charging" mode. This is a
mode that allows fine control of charging, selling, and load support. It does not visibly affect operation.
The <Graph> soft key brings up a series of screens which plot various types of data over time on the
MATE3 screen.

Battery Screen

The <Next> soft key brings up a screen showing charger status, charger settings, and battery voltage
and temperature information.
Screen items:

Actual displays the uncompensated battery voltage.

Absorb displays the charger's Absorption voltage setting. (See page 35.)

Float
displays the charger's Float voltage setting. (See page 36.)

Equalize displays the charger's Equalization voltage setting. (See page 40.)

Temp Comp
displays the corrected battery voltage using temperature readings from the Remote
Temperature Sensor (RTS). If no RTS is present,

Batt Temp displays the battery temperature in degrees Celsius, as measured by the RTS. This reading is
only valid for port 1 on the HUB product. If other ports are selected, or if no RTS is present, the characters
### will be displayed.

Re-Float displays the Re-Float setting which was programmed into the inverter's charger. This is the
voltage used for the inverter to return from Silent mode to the float stage. (See page 36.)

Sell RE voltage is the target voltage used by the inverter for both the Offset and grid-interactive functions
when the charger is otherwise inactive. (See pages 19 and 42.)
The <Warn> and <Error> keys bring up screens with various fault information. See the next section.
56
Charge and Load .
.
NOTE: The charger settings cannot be adjusted on this screen.
An arrow will appear to the right of
indicate that the charger is in that stage. The arrow will not appear if
the charger is in the Bulk stage, or if it is inactive.
Figure 21
Temp Comp
Absorb, Float
Battery Screen
and Actual will read the same. (See page 41.)
Equalize
, or to
900-0167-01-00 Rev A