DFI G5G330-P User Manual page 84

3
BIOS Setup
EPP Mode Select
This field is used to select the EPP mode.
ECP Mode Use DMA
This is used to select a DMA channel of the parallel port.
PWRON After PWR-Fail
Off
On
Former-Sts When power returns after an AC power failure, the
Serial Port 1 Mode
COM 1 functions as a serial port or IrDA. You cannot use both at
the same time.
Normal
IrDA
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to manu-
Disabled Disables the onboard serial port 1 and/or serial port 2.
84
When power returns after an AC power failure, the
system's power is off. You must press the Power
button to power-on the system.
When power returns after an AC power failure, the
system will automatically power-on.
system will return to the state where you left off
before power failure occurs. If the system's power is
off when AC power failure occurs, it will remain off
when power returns. If the system's power is on
when AC power failure occurs, the system will power-
on when power returns.
This option sets COM 1 as serial port.
This option sets COM 1 as IrDA.
The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
ally select an I/O address for the onboard serial port 1
and serial port 2.