Assigning System Settings - Schwinn MPower Echelon2 Console Installation Manual

ASSIGNING SYSTEM SETTINGS

The picture below shows the optional system settings and how to assign settings.
Below is a description of each setting. NOTE: The Gear setting and Calibration
settings are not used unless the optional power upgrade kit is installed.
Carbon Blue
This setting is used to distinguish between Carbon Blue bike with a belt and bikes with a
chain. The default setting is ON. Leave this setting set to ON for Carbon Blue models.
On models with chain, set it to OFF.
Gear
This is an optional setting that enables the console to display a gear number that
corresponds to the level of resistance. When set to ON, a gear symbol and gear number
will be displayed on the right side of the console next to the calories value. This setting
is set to OFF by default.
Units
The units refer to the distance. The two optional settings are miles or kilometers. The
default setting is miles.
Open Ant Channel
This setting is used to turn on the channel that broadcasts data to external leaderboard
systems that display console data on a large screen. This must be set to ON in order
for external systems to read data from the console. It is set to OFF by default. Leaving
this setting off when not used conserves battery life.
Backlight
This setting allows the user to set the backlight display to a number of settings. In the
BACKLIGHT SETTING submenu the backlight can be set as follows:
 Backlight displays for 10 seconds when the LIGHT button is pressed in Ride
mode (this is the default setting)
 Backlight displays for 15 seconds when the LIGHT button is pressed in Ride
mode
 Backlight displays for 20 seconds when the light button is pressed in Ride mode
 When set to ON, the backlight will always be on when the console is on
 When set to OFF, the backlight cannot be used when the console is on
In the BACKLIGHT HOLD submenu the backlight display can be set as follows:
24 | P a g e M P o w e r E c h e l o n 2 I n s t a l l a t i o n G u i d e