Optional Power Upgrade Kit Installation On Ac Sport And Ac Performance - Schwinn MPower Echelon2 Console Installation Manual

Optional Power Upgrade Kit Installation on AC Sport and AC Performance

NOTE: When installing the power upgrade kit, do not use the console-to-RPM sensor
cable (Item 5) from the console kit. This cable is not used when installing the power
upgrade kit. Use the console-to-power cable (Item 2) in the power kit to connect the
console to the power sensor. Use the RPM-to-power cable (Item 3) in the power kit to
connect the RPM sensor to the power sensor; this cable is the shorter cable with a two-
pin connector on each end of the cable
1. Repeat Step 1-9, and 11-21 from the console kit installation instructions above.
NOTE: The difference at this point will be that the cable from the console will not be
plugged into the RPM sensor. The RPM sensor cable will have one free end after
installing the RPM sensor on the bike and routing the ROM cable through the cable
duct. The console-to-power cable has different lengths of unshielded wires at each
end as show below
with the shorter length of unshielded wires (shown in the right) plugs into the
console. The end with the longer length of unshielded wires (shown on the left) is
routed through the cable duct and plugged into the power sensor.
11 | P a g e
. (Figure 25)
Figure 25
and has RJ45 connectors on both ends. The end
in Figure 26
Figure 26
M P o w e r E c h e l o n 2 I n s t a l l a t i o n G u i d e