System Learning And Led Display - TMT Automation Boxer 300 User Manual

3.2 TRANSMITTER MEMORIZING
Press "RF-learn" button for 2 seconds, and the Blue LED will be on; then press the transmitter (A) button;
The Blue LED will blink twice and stay on for 10 seconds then be off. And the remote memorize has completed.
LED1
LED2
LED3
2 Sec
1

3.3 SYSTEM LEARNING AND LED DISPLAY

! CAUTION: Before proceeding to system learning, the transmitter memorizing process has to be completed.
To complete the system learning, follow the instructions below:
Step1: Press "SET"; then press "SET" + "DOWN" for 3 seconds, and the LED display shows "LEA"
LED1
Stop2: Press button (A) on time, the LED display should shows "ARN"
LED2
ON
Step3: The gate will goes to Auto-learning, please wait for the learning process to be completed
LED3
OFF
1
A B
ON
OFF
4
LED Display
"N-L": The Boxer system learning is not done.
"RUN": The Boxer system is in normal operation
To program, press SET button for 3 seconds, when the LED display change from RUN to F1,
press UP or DOWN to change function settings (F1 to FA). Then press SET to enter the sub
function within each group, press UP or Down to select sub functions and press SET for
confirmation.
"LEA": Enter learning mode and then wait for learning instructions.
"ARN": The system learning is in progress.
The Auto-learning process of gate moving:
"Gate open to the end- stop close to the end- stop."
BOXER SERIES SLIDING GATE OPENER USER MANUAL
A
Blue LED
2
LED1
LED2
LED3
Push
2
Press
1~3 Sec
5
B
Blue LED on the RF learning board
Press
3 Sec
ON
OFF
Programmable Functions
Blue LED
3
3
6
7