Matrix A7XI-01 Service Manual page 147

cHAPter 10: Ascent trAiner sPecificAtions And AsseMbly gUide
10.7 netPUlse & AM setting UP soP
2. Network Setting.
a. Wired Solutions
Once the Ethernet cabling that has been installed in the facility, the console should automatically recognize and connect to the network via the
Ethernet Cable. Select the Network to obtain the network setting screen, press the right/left arrow to switch the screen to wired network setup
screen (Figure D).
b. Wireless Solutions
i. The console must be connected to the network via the wireless module built into the console.
ii. Select the Network to obtain the network setting screen, press the right/left arrow to switch the screen to wired network setup screen
(Figure E).
iii. Select 'Site Survey" to see all available networks, select the SSID 'npwireless' from the list, if the "npwireless" access point is not
visable, please key in the "npwireless" SSID by manual.
iv. If the facility is using a different SSID, select the correct SSID.
v. Touch the window provided for entering the pass phrase, Enter the password provided by Matrix Fitness for the npwireless SSID.
vi. Press Connect.
vii. The network screen will show the network connect successful or fail to connect
viii. Netpulse setting, testing and installing, select the Netpulse to obtain the Netpulse screen, press Test Network can test the network
status Fail or passed; if the network was passed, then we can install the netpulse as well (Figure F).
ix. Press Home button to return to Main screen (Figure G), now very thing was setup on the console.
144
figUre d
figUre f
figUre e
figUre g