Matrix A7XI-01 Service Manual page 103

cHAPter 9: PArt rePlAceMent gUide
9.13 incline Motor rePlAceMent - continUed
7) While the incline motor is out, the carriage rollers should be checked. Turn the rollers. The rollers should turn smoothly with only a small
amount of friction (Figure E).
8) If the rollers need to be adjusted, loosen the horizontal bolts simultaneously first, then adjust the roller friction by adjusting the vertical screws
simultaneously (Figure F).
figUre e
figUre f
9) Prepare the new incline motor for installation. The new incline motor should have the nut placed close to the end of the shaft (Figure G).
figUre g
100