Trouble Shooting - Prem-I-Air EH0530 Instruction Manual

L. TROUBLE SHOOTING
Please check the following items before asking for repairing:
PROBLEMS
The unit does not work
The unit stops running
automatically
In cooling mode, no cooling
air coming out
The remote control does
not work
The unit does not work for
3 minutes when switched
on.
Error code "E2" in LED
display
Error code "E4" in LED
display
Error code "E5" in LED
display
Error code "E6" in LED
display
Yellow light flashing
Error codes are for information only. Advise your local service agent as
appropriate.
CAUSES
Power supply fault:
1. Not plugged in;
2. Faulty plug or socket;
3. Fuse broken
1. Timer is set or room
temperature is lower than
set temperature.
2. The water tank is full.
1. Room temperature is
lower than set temperature.
2. There is frost on the
surface of evaporator.
1. Exhausted batteries
2. Batteries incorrectly
installed.
Protection of the unit.
Failure of the indoor sensor.
Failure of the indoor coil
sensor.
Failure of the upper fan
motor
Failure of the water tray full
The unit is in defrosting
operation
Page 22
SUGGEST SOLUTIONS
1. Plug in correctly;
2. Change the plug or socket;
3. Replace fuse
1. Close the timer or reset
temp.
2. Drain off the water.
1. This is normal.
2. The unit is defrosting and it
will run when the defrosting is
finished.
1. Change the batteries.
2. Re-install the batteries
correctly
Wait for approx.3 minutes and
the unit will start.
Advise your local services
Advise your local services
Advise your local services
Refer to page 18
The unit will return to normal
once defrosting is finish.